The hollow PC board can be cut with a sharp utility knife and the solid PC board can be cut with a hand saw. When cutting, the board should be fixed to avoid tearing caused by violent vibration.

When installing the PC board, the side marked with UV protection is facing outwards.

Before installation, all the ends of the panel should be sealed with aluminum sealing tape.

During the installation process, the construction personnel must not directly stand on the PC board.

After completion of construction, the debris on the PC board should be cleaned up.

Regular cleaning in accordance with the correct method and appropriate tools can extend the service life of the PC board.

Rinse with warm water: Rinse with neutral soap or household detergent mixed with warm water and remove dust and dirt with a soft fabric or sponge.

Rinse with cold water and wipe dry spots with a soft cloth.

Rinse with tap or high pressure water gun;

Water add-ons should be compatible with PC board.

Do not polish or clean the PC board with strong alkali.

Do not use a dry cloth or hard brush to wipe the surface, so as not to produce hair phenomenon.

Do not use butylcellosolve and isopropyl alcohol solution to clean UV resistant PC board.

Dehydrated alcohol, petroleum ether(BP65), ethane, conane